Nitrogen-doped cobalt sulfide as an efficient electrocatalyst for hydrogen evolution reaction in alkaline and acidic media

The enhancement in intrinsic catalytic activity and material conductivity of an electrocatalyst can leads to promoting HER activity. Herein, a successful nitrogenation of CoS₂ (N–CoS₂) catalyst has been investigated through the facile hydrothermal process followed by N₂ annealing treatment. An optimized N–CoS₂ catalyst reveals an outstanding hydrogen evolution reaction (HER) performance in alkaline as well as acidic electrolyte media, exhibiting an infinitesimal overpotential of ?0.137 and ?0.097 V at a current density of ?10 mA/cm² (?0.309 and ?0.275 V at ?300 mA/cm²), corresponding respectively, with a modest Tafel slope of 117 and 101 mV/dec. Moreover, a static voltage response was observed at low and high current rates (?10 to ?100 mA/cm²) along with an excellent endurance up to 50 h even at ?100 mA/cm². The excellent catalytic HER performance is ascribed to improved electronic conductivity and enhanced electrochemically active sites, which is aroused from the synergy and mutual interaction between heteroatoms that might have varied the surface chemistry of an active catalyst.     

Sputtered Ir–Ru based catalysts for oxygen evolution reaction: Study of iridium effect on stability

Magnetron sputtered low-loading iridium-ruthenium thin films are investigated as catalysts for the Oxygen Evolution Reaction at the anode of the Proton Exchange Membrane Water Electrolyzer. Electrochemical performance of 50 nm thin catalysts (Ir pure, Ir–Ru 1:1, Ir–Ru 1:3, Ru pure) is tested in a Rotating Disk Electrode. Corresponding Tafel slopes are measured before and after the CV-based procedure to compare the activity and stability of prepared compounds. Calculated activities prior to the procedure confirm higher activity of ruthenium-containing catalysts (Ru pure > Ir–Ru 1:3 > Ir–Ru 1:1 > Ir pure). However, after the procedure a higher activity and less degradation of Ir–Ru 1:3 is observed, compared to Ir–Ru 1:1, i.e. the sample with a higher amount of unstable ruthenium performs better. This contradicts the expected behavior of the catalyst. The comprehensive chemical and structural analysis unravels that the stability of Ir–Ru 1:3 sample is connected to RuO₂ chemical state and hcp structure. Obtained results are confirmed by measuring current densities in a single cell.     

Swapping catalytic active sites from cationic Ni to anionic F in Fe–F–Ni3S2 enables more efficient alkaline oxygen evolution reaction and urea oxidation reaction

Electrolysis of water for producing hydrogen instead of traditional fossil fuels is one of the most promising methods to alleviate environmental pollution and energy crisis. In this work, Fe and F ion co-doped Ni₃S₂ nanoarrays grown on Ni foam substrate were prepared by typical hydrothermal and sulfuration processes for the first time. Density functional theory (DFT) calculation demonstrate that the adsorption energy of the material to water is greatly enhanced due to the doping of F and Fe, which is conducive to the formation of intermediate species and the improvement of electrochemical performance of the electrode. The adsorption energy of anions (F and S) and cations (Fe and Ni) to water in each material was also calculated, and the results showed that F ion showed the most optimal adsorption energy of water, which proved that the doping of F and Fe was beneficial to improve the electrochemical performance of the electrode. It is worth noting that the surface of Fe–F–Ni₃S₂ material will undergo reconstruction during the process of water oxidation reaction and urea oxidation reaction, and amorphous oxides or hydroxides in situ would be formed on the surface of electrode, which are the real active species.     

Highly stable γ-NiOOH/ZnCdS photocatalyst for efficient hydrogen evolution

It is extremely desirable to develop high hydrogen evolution activity and stable visible-light-driven photocatalysts. The sluggish oxidation process and holes accumulation are the main obstacles to high catalysis activity and photo-stability. An efficient γ-NiOOH/ZnCdS photocatalyst was prepared by in-situ hydrothermal method. The γ-NiOOH nanosheets distribute on ZnCdS nanospheres surface and accelerate holes transfer. The hydrogen evolution rate is up to 48.60 mmol g^?1 h^?1 under visible-light illumination (λ = 400–780 nm), about 10.8 times of pure ZnCdS (4.50 mmol g^?1 h^?1) and 1.8 times of general β-NiOOH modified ZnCdS (27.40 mmol g^?1 h^?1). And apparent quantum yield of γ-NiOOH/ZCS-100 is up to 18.23% (400 nm). The carrier lifetime extends from 5.50 ns (ZnCdS) to 6.10 ns (γ-NiOOH/ZCS), examined by steady photoluminescence and time-resolved photoluminescence. Moreover, the γ-NiOOH/ZCS photocatalyst has exhibited excellent photo-stability even after one-year of storage. The γ-NiOOH nanosheets can be an excellent co-catalyst on accelerating both holes transfer and oxidation process for high photo-stability and photo-activity.     

Enhanced oxygen evolution reaction kinetics through biochar-based nickel-iron phosphides nanocages in water electrolysis for hydrogen production

Highly-efficient and stable non-noble metal electrocatalysts for overcoming the sluggish kinetics of oxygen evolution reaction (OER) is urgent for water electrolysis. Biomass-derived biochar has been considered as promising carbon material because of its advantages such as low-cost, renewable, simple preparation, rich structure, and easy to obtain heteroatom by in-situ doping. Herein, Ni₂P–Fe₂P bimetallic phosphide spherical nanocages encapsulated in N/P-doped pine needles biochar is prepared via a simple two-step pyrolysis method. Benefiting from the maximum synergistic effects of bimetallic phosphide and biochar, high conductivity of biochar encapsulation, highly exposed active sites of Ni₂P–Fe₂P spherical nanocages, rapid mass transfer in porous channels with large specific surface area, and the promotion in adsorption of reaction intermediates by high-level heteroatom doping, the (Ni_0.75Fe_0.25)₂P@NP/C demonstrates excellent OER activity with an overpotential of 250 mV and a Tafel slope of 48 mV/dec at 10 mA/cm² in 1 M KOH. Also it exhibits a long-term durability in 10 h electrolysis and its activity even improves during the electrocatalytic process. The present work provides a favorable strategy for the inexpensive synthesis of biochar-based transition metal electrocatalysts toward OER, and improves the water electrolysis for hydrogen production.     

Experimental and numerical study on tube-side flow and heat transfer characteristics of superheated vapor flow in catalyst-filled LH2 spiral wound heat exchanger

High energy consumption is considered to be one of the most persistent problems in liquid hydrogen (LH₂) plants. The combination of heat exchanger and ortho-para (O–P) hydrogen conversion has attracted considerable attention as a cutting-edge technology to reduce energy consumption. The flow and heat transfer characteristics of O–P hydrogen conversion catalyst-filled spiral wound heat exchanger (SWHE) were investigated in this study in two steps. In the first step, pressure-drop experiments were performed in a tube filled with porous media. The results indicated that the pressure drop was overestimated when using Ergun's equation. Therefore, a new empirical pressure-drop correlation for a channel filled with O–P catalyst was formulated. Subsequently, a novel heat transfer model was established based on this correlation for further numerical simulations. The distributions of the temperature, pressure, and para hydrogen content in a catalyst-filled tube were determined. In addition, the influence of the flow rate on the heat exchange coefficient and outlet para hydrogen was clarified; it was found that, with an increase in the flow rate, the heat exchange coefficient increased, whereas the outlet para hydrogen content decreased. At a flow rate of 0.5 m³/h, the para hydrogen content increased by 44% after hydrogen flowed through the channel filled with the O–P catalyst. Furthermore, a prediction model for the para hydrogen content with a flow rate range of 0–1.5 m³/h was derived. This study provides promising theoretical evidence for the engineering application of SWHEs filled with O–P catalysts in large-scale hydrogen liquefaction units.     

猪胴体冷却降温特性及耗能分析

猪肉是我国消耗量最大的肉类品，尤其是冷鲜猪肉更受人们青睐。猪胴体冷却保鲜加工工艺既要满足优质猪肉的成熟条件，又要保证猪肉的安全卫生。猪胴体冷却温度和降温速度对保证加工工艺合理性和降低耗能都至关重要。在实测数据基础上经过判断、分析提出，在常规0～4 ℃冷却前先在-10～-5 ℃低温快速冷却猪胴体1 h从而更好地保证猪胴体的冷却效果。实验发现：猪胴体开始冷却时，内部温度先有2～4 ℃的升温，然后才会降温，因此需对热负荷计算进行修正；根据两段冷却过程中猪胴体的冷却降温特点，提出了对应的冷量要求，为配备冷却装置提供了依据。     

Lactobacillus reuteri-fortified camel milk infant formula: Effects of encapsulation,in vitro digestion,and storage conditions on probiotic cell viability and physicochemical characteristics of infant formula

Lactobacillus reuteri fortified camel milk infant formula (CMIF) was produced. The effect of encapsulation in different matrices (sodium alginate and galacto-oligosaccharides) via spray drying, simulated infant gastrointestinal digestion (SIGID), and storage conditions (temperature and humidity) on the viability of L. reuteri in CMIF and the physicochemical properties of CMIF were evaluated. Compared with free cells, probiotic cell viability was significantly enhanced against SIGID conditions upon encapsulation. However, L. reuteri viability in CMIF decreased after 60 d of storage, predominantly at higher storage humidity and temperature levels. At the end of the storage period, significant changes in the color values were observed in all CMIF, with a reduction in their greenness, an increase in yellowness, and a wide variation in their whiteness. Moreover, pH values and caking behavior of all CMIF stored at higher temperature (40°C) and humidity [water activity (a_w) = 0.52] levels were found to be significantly higher than the samples stored under other conditions. Over 30 d of storage at lower humidity conditions (a_w = 0.11 and 0.33) and room temperature (25°C), no significant increase in CMIF lipid oxidation rates was noted. Fourier-transform infrared spectroscopy analysis showed that, compared with the other storage conditions, CMIF experienced fewer changes in functional groups when stored at a_w = 0.11. Microscopic images showed typical morphological characteristics of milk powder, with round to spherical-shaped particles. Overall, camel milk fortified with encapsulated L. reuteri can be suggested as a promising alternative in infant formula industries, potentially able to maintain its physicochemical characteristics as well as viability of probiotic cells when stored at low humidity levels (a_w = 0.11) and temperature (25°C), over 60 d of storage.     

Experimental evaluation of the luminescence performance of fired clay brick coated with SrAl2O4:Eu/Dy phosphor

This study evaluates the luminescence performance of fired clay bricks coated with SrAl₂O₄:Eu/Dy phosphor. To do so, SrAl₂O₄:Eu/Dy phosphor was first produced using the traditional solid-state reaction synthesis technique. The prepared phosphor was then used for coating fired clay bricks to analyze the luminescence performance via spectral analysis, decay characteristics, and microstructure of the bricks. The results reveal that excitation and emission spectra of the phosphor coated bricks range from 200 to 480 nm and 455 to 650 nm, respectively, suggesting that the phosphor coated bricks have the capacity of absorbing light with a wide range of wavelengths. The peak wavelength projected at 511 nm in the emission spectrum is achieved, which indicates 4f⁶5 d¹-4f⁷ transition of Europium (Eu²⁺). The repeated excitation and deexcitation of Eu²⁺ by using hole traps and trap levels offered by Dysprosium (Dy³⁺), exist between the ground and the excited state of Eu²⁺ leads to luminescent phenomenon. Moreover, the decay characteristics has revealed that phosphor coated bricks can emit light for a considerable amount of time (>8.5 min) upon the removal of the excitation source. The results reveal that phosphor coated bricks has the potential of increasing energy efficiency of residential and commercial buildings.     

Hydrangea like composite catalysts of ultrathin Mo2S3 nanosheets assembled on N,S-dual-doped graphitic biocarbon spheres with highly electrocatalytic activity for HER

Water electrolysis is the most clean and high-efficiency technology for production of hydrogen, an ultimate clean energy in future. Highly efficient non-noble electrocatalysts for hydrogen evolution reaction (HER) are desirable for large scale production of hydrogen by water electrolysis. Especially, exposing as many active sites as possible is a vital way to improve activities of the catalysts. Herein, a series of new hydrangea like composite catalysts of ultrathin Mo₂S₃ nanosheets assembled uprightly and interlacedly on N, S-dual-doped graphitic biocarbon spheres were facilely prepared. The unique structure endowed the catalysts highly exposed edge active sites and prominently high activities for HER. Especially, the optimized catalyst Mo₂S₃/NSCS-50 exhibited as low as 106 mV of overpotential at 10 mA/cm² (denoted as ?₁₀). The catalyst also showed low Tafel slope of 53 mV/dec, low electron transfer resistance of 34 Ω and high stability evidenced by the result that the current density only attenuated 11.7% after 10 h i-t test. The catalyst has shown broad prospect for commercial application in water electrolysis.